TT Roadster L4-1.8L Turbo (AWP) (2003)
-
Unclip wiring harness -A-.
-
Disconnect printed circuit board with integrated Tiptronic switch - F189 - from guides of frame (arrows).
-
Check that solenoid (arrow) on cross roller of screen is firmly seated; if necessary replace screen, Fig. 2 and Fig. 3.
Installing
Installation is in reverse order. Note the following:
-
Position printed circuit board with holes on guides of frame (arrows).
-
Clip wiring harness -A- into frame ensuring that printed circuit board does not become deformed.
-
Install rear center console.
-
Install selector lever handle.