TT Roadster L4-1.8L Turbo (AWP) (2003)
/Page-3759003.png)
-
Pull connector - 1 - off speed sensor.
-
Unclip speed sensor wiring from retainer.
-
Remove bolts - 1 - with vehicle standing on its wheels (if necessary, raise vehicle until bolts are accessible).
-
Raise vehicle to working height; this relieves load on coil spring.
-
Remove spring.
Installing spring
-
Ensure zinc packing is not damaged.
-
Replace if necessary.
-
Install spring together with spring seat.
-
Observe installation position!
-
End of spring (arrow) must lie against stop on spring seat.
