TT Roadster L4-1.8L Turbo (AWP) (2003)
/Page-2635004.png)
ATF present in overflow pipe runs out first (arrow - 2 -).
If ATF emerges via overflow pipe from ATF inspection aperture before ATF has reached 40°C, ATF level is OK.
-
Tighten ATF inspection plug (arrow - 1 -) with new seal to 27 Nm. ATF check is now complete.
Note: The ATF inspection plug must be screwed in again before the ATF reaches a temperature of 45°C). 1) 50°C for tropical countries
If no ATF emerges from ATF inspection aperture by the time ATF has reached 45°C, top off ATF
-
Exit function "08 - Read measured value block" by pressing * key.
-
Press "06 - End output".
-
Switch off ignition and disconnect Data Link Connector (DLC).
Filling ATF
If no ATF emerges via overflow pipe (arrow - 2 -) at ATF inspection aperture by the time ATF has reached 40°C, ATF must be topped off.
Note: The ATF inspection plug must at the latest be resealed on reaching a temperature of 45°C). Switch engine off if necessary, allow transmission
to cool down and repeat the test.
1) 50°C for tropical countries
-
Remove sound insulation tray (arrows).
