TT Roadster L4-1.8L Turbo (AWP) (2003)
Shift Interlock Cable: Adjustments
Locking cable, adjusting, 09G, 6 Speed A/T
CAUTION! Adjustment of the locking cable must always be performed as described below.
Adjustment requirements
^
Locking cable in installation position
^
Rear center console removed.
^
Selector lever in "P" position.
^
Ignition key inserted and ignition switched off
Adjustment sequence
^
Steering column is in back/down position.
-
Loosen bolt at support bracket.
-
Install adjustment gauge 3352 A between locking lever - 1 - and locking cable eye - 2 -.
-
To compensate for play, pull support bracket up to limit stop in direction of arrow.
It must be possible to remove and insert adjustment gauge 3352 A easily in this position.
-
Tighten bolt at support bracket (10 Nm).
-
Remove setting bar.
-
Check function of ignition key removal lock.