TT Roadster L4-1.8L Turbo (AWP) (2003)
/Page-2748002.png)
-
Clamp off hoses of ATF cooler with 3094 and disconnect from ATF cooler.
-
Remove ATF cooler - 1 - from transmission (arrow -A-).
Installing
Installation is in reverse order. Note the following:
-
Replace O-rings of ATF cooler.
-
Dished washer (Item - 6 -) must be installed so that it lies on washer (Item - 5 -), with convex side of dished washer facing up.
-
When installing ATF cooler - 1 -, fit tab (arrow -B-) in recess of transmission housing.
-
Tighten bolt (arrow -A-) to 36 Nm.
-
Check coolant level in cooling system:
-
Check and top up ATF level.
