TT Roadster L4-1.8L Turbo (AWP) (2003)
/Page-2774002.png)
-
Disconnect 14-pin connector -A- from transmission connector.
Continuation for all:
-
Remove securing bolt of 14-pin connector on outside of transmission housing.
-
Remove connector from transmission housing and carefully guide wiring harness -D- after it.
Installing
Installation is performed in the reverse order; note the following:
-
Install a new O-ring on connector.
-
Coat O-ring with ATF.
-
Press connector with O-ring installed to limit stop in transmission.
-
Tighten bolt for connector to 5.5 Nm.
