TT Roadster L4-1.8L Turbo (AWP) (2003)
Seals and Gaskets: Service and Repair
Flange shaft oil seals, replacing (transmission installed)
-
Observe general repair instructions.
Special tools and workshop equipment required
^
VW 771 Multi - purpose tool
^
VW 771/37 Puller hooks
^
3106 Drift
Removing
Before replacing left- hand oil seal:
-
Remove drive axle
Before replacing right- hand oil seal:
-
Turn steering to right to full lock stop.
-
Remove drive axle protective shield from engine, if fitted.
-
Disconnect drive axle from flange shaft.
-
Tie - up drive axle as high as possible. Do not damage paint on drive axle.
-
Place drip tray underneath.
-
Remove flange shaft cone head bolt.