TT Roadster L4-2.0L Turbo (BPY) (2008)
Installation
-
Insert central tube in body according to markings applied.
-
Hand tighten left and right front wiring guide on central tube.
-
Align central tube according to markings applied to A-pillar during removal.
-
Tighten left and right central tube nuts.
Further installation is performed in reverse sequence of removal, but observe the following:
-
Install Headlamp Range Control Module (J431). See: Lighting and Horns/Headlamp
-
Tighten steering column on steering column mounting bracket.
-
If present, install Telephone Amplifier (R86) on right bracket.
-
Install left instrument panel fuse holder.
Check location of instrument panel central tube
-
Insert instrument panel to test.
-
Secure instrument panel at left and right to instrument panel central tube.
-
Close doors.
-
Check whether gap dimension between instrument panel and left and right doors is even.
-
Check whether height of instrument panel aligns with molding in door trim.
If the adjustment is not correct:
-
Note side or height deviation.
-
Remove instrument panel again.
-
Loosen instrument panel central tube screws.
-
Adjust instrument panel central tube according to noted deviations.
-
Tighten left and right instrument panel central tube bolts - 2 - and - 4 -.
‹› The driver side tunnel support reinforcement is only for the Roadster.