TT Roadster L4-2.0L Turbo (BPY) (2008)
Glove Compartment: Removal and Replacement
Glove Compartment Opener With Lock, Removing and Installing
Glove Compartment Opener With Lock, Removing And Installing
Removing
-
Remove glove compartment cover trim.
-
Remove bolt - 1 -.
-
Using a screwdriver, press tabs - 2 - on side of glove compartment opener down.
-
Remove glove compartment opener - 3 - with lock - arrow -.
NOTE: It is only possible to remove lock cylinder with key inserted.
-
Drive out pin - 1 - with a drift.
-
Remove cover cap - 2 -.
-
Using a screwdriver, carefully pry retaining pins - 1 - and - 3 - in - direction of arrow - and at the same time, remove lock cylinder - 2 - from glove
compartment opener.
Installing
Installation is reverse of removal, but note the following:
-
With key inserted, press lock cylinder in until it engages in all retaining pins.