TT Roadster L4-2.0L Turbo (BPY) (2008)
Scuff Plate: Service and Repair
Rear Cross Panel Trim, Removing and Installing
Rear Cross Panel Trim, Removing And Installing
Special tools, testers and auxiliary items required
-
Trim removal wedge 3409
Removing
-
Fold luggage compartment floor mat completely forward.
-
Remove luggage compartment floor covering.
-
Unclip rear cross panel trim - 1 - up vertically using Trim Removal Wedge 3409.
Installing
Installation is reverse of removal. Observe the following when doing so:
NOTE: Check clips for damage or deformation, replace if necessary.
-
Insert rear cross panel trim - 1 - so it engages with left and right retainers in pins - 3 - and eyes - 4 -.
-
Stretch rear lid seal lip - 2 - over rear cross panel trim - 1 -.