TT Roadster L4-2.0L Turbo (BPY) (2008)
Trim Panel: Service and Repair
Sill Panel Trim
Sill Panel Trim
Special tools, testers and auxiliary items required
‹› Trim Removal Wedge (3409)
Removing
-
Remove rear bulkhead side trim - 1 - in transition area to sill panel strip - 3 - from body => [ Rear Bulkhead Side Trim ].
-
Unclip sill panel strip - 3 - with Trim Removal Wedge (3409).
Installation
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
‹› If trim clamps remain in body mounting points, remove these and insert them in trim.
‹› Check clamps for damage or deformation, replace if necessary.
‹› Lower A-pillar trim - 4 - must be installed.
-
Stretch door seal lip - 2 - over sill panel strip - 3 - and rear bulkhead side trim - 1 -.