TT Roadster L4-2.0L Turbo (BPY) (2008)
Trim Panel: Service and Repair
Rollover Protection Trim
Rollover Protection Trim
Special tools, testers and auxiliary items required
‹› Trim Removal Wedge (3409)
Removing
‹› The rear bulkhead cover is only laid aside and is not removed completely.
Loosen rear bulkhead cover (without remove seat belt from outer floor assembly mounting points)and lay cover aside. Refer to => [ Rear Bulkhead
Cover Assembly Overview ] See: Service and Repair/Removal and Replacement
-
Remove clamps - 1 - from front part of rollover protection trim - 2 - and body.
-
Beginning at the bottom, unclip the front part of the rollover protection trim - 2 - from the rollover protection using the Trim Removal Wedge
(3409).
-
Remove bolts - arrows - and remove rollover protection bracket - 3 -.
-
Remove back part of rollover protection trim - 4 - from rollover protection.
Installation
To install, perform the steps used in removal in reverse order.
Tightening specifications, refer to => [ Rollover Protection Trim Assembly Overview ] See: Service and Repair/Removal and Replacement.