TT Roadster L4-2.0L Turbo (BPY) (2008)
‹› Do not oil
5
Sealing flange, front
‹› Must sit on alignment pins
‹› Removing and installing => [ Front Sealing Flange ] See: Front Sealing Flange
6
Alignment pins
7
Toothed belt gear diamond disc
‹› Replace after removing toothed belt gear
8
Bolt
‹› Tightening order => [ Tightening sequence of front sealing flange ]
9
Cylinder block
‹› Removing and installing crankshaft => [ Crankshaft Assembly Overview ] See: Crankshaft/Service and Repair/Crankshaft Assembly Overview
‹› Piston and connecting rod, disassembling and assembling => [ Pistons and Connecting Rods Assembly Overview ] See: Piston/Service and
Repair
Tightening sequence of front sealing flange
-
Proceed as follows:
-
Install bolts - 1 to 10 - and tighten by hand.
-
Tighten bolts - 1 to 6 - diagonally in stages to 15 Nm.
-
Tighten bolts - 7 to 10 - to 15 Nm.