TT Roadster L4-2.0L Turbo (BPY) (2008)
Drive Belt: Service and Repair
Ribbed Belt, Assembly Bracket Assembly Overview
Ribbed Belt, Assembly Bracket Assembly Overview
‹› Before removing ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt
under operating conditions. When installing, make sure the belt is correctly seated in the belt pulley.
1
Vibration damper
‹› For ribbed belt
‹› Removing and installing => [ Vibration Damper ] See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and Repair
2
Bolt
‹› 10 Nm plus an additional 90° turn
Replace
3
Bolt
‹› 23 Nm
4
Tensioning device for ribbed belt
‹› To release tension on ribbed belt, pivot using open-end wrench.
‹› Secure tensioner with special tool Locking Pin ( T10060A)