TT Roadster L4-2.0L Turbo (BPY) (2008)
‹› Pay attention to alignment sleeves => [ Balance Shaft Module with Oil Pump Assembly Overview ] See: Cylinder Block Assembly/Balance
Shaft/Service and Repair/Balance Shaft Module With Oil Pump Assembly Overview
‹› Balance shaft module with oil pump, assembly overview => [ Balance Shaft Module with Oil Pump Assembly Overview ] See: Cylinder Block
Assembly/Balance Shaft/Service and Repair/Balance Shaft Module With Oil Pump Assembly Overview
‹› Removing and installing => [ Balance Shaft Module with Oil Pump ] See: Cylinder Block Assembly/Balance Shaft/Service and
Repair/Balance Shaft Module with Oil Pump
7
Bolt
‹› Replace
‹› Note different length of bolts => [ Bolt allocation for balance shaft housing ] See: Cylinder Block Assembly/Balance Shaft/Service and
Repair/Balance Shaft Module With Oil Pump Assembly Overview
‹› Tightening order => [ Balance shaft housing tightening sequence ] See: Cylinder Block Assembly/Balance Shaft/Service and Repair/Balance
Shaft Module With Oil Pump Assembly Overview
8
Bolt
‹› Tightening sequence => [ Oil pan tightening sequence ]
9
Oil pan
‹› Clean sealing surface before installing
‹› Removing and installing => [ Oil Pan ] See: Oil Pan
10
Bolt
‹› Tightening sequence => [ Oil pan tightening sequence ]
11
Seal
‹› Rolled onto => [ (Item 12) Oil drain plug ].
12
Oil drain plug
‹› 30 Nm
‹› With permanent sealing ring
‹› Replace
13
Chain sprocket
14
Bolt
‹› 10 Nm
15
Protective cap
16
Oil Level Thermal Sensor (G266)
17
Seal
‹› Replace
‹› Oil before assembling
18
Bolt
‹› 20 Nm plus an additional 90° turn