TT Roadster L4-2.0L Turbo (BPY) (2008)
Crankshaft Main Bearing Seal: Service and Repair
Rear Sealing Flange and Dual-Mass Flywheel Assembly Overview
Note:
^
Servicing clutch
1 - Bolt
^
For dual-mass flywheel/drive plate
^
60 plus an additional 90 degree (1/4 turn)
^
Replace
2 - Dual mass flywheel
^
Only possible to install in one position. Bores are offset.
3 - Intermediate plate
^
Must be located on dowel sleeves
^
Do not damage or bend when doing assembly work
4 - Bolt
^
Tightening order
5 - Sealing flange with rear oil seal
^
Only replaced as complete unit
^
To install, use provided guide sleeve
^
Do not oil or grease sealing lip of oil seal
^
Before installing, remove oil remains from crankshaft journal with a clean cloth
^
Guide sleeve may only be removed after sealing flange has been slid onto crankshaft pin.