TT Roadster L4-2.0L Turbo (BPY) (2008)
Condenser HVAC: Service and Repair
Condenser, Removing and Installing
Condenser, Removing And Installing
NOTE: Condenser is available in different versions, depending on version of vehicle.
Condenser, Vehicles With 4-cyl. Engine, Removing And Installing
NOTE: The following describes removal and installation on a vehicle with a 2.0LTFSI engine. On vehicles with a different 4-cyl. engine, the procedure
may differ.
Removing
-
Switch off ignition.
-
Discharge refrigerant circuit.
-
Remove fan shroud.
-
Disconnect refrigerant lines from condenser.
-
Remove front bumper cover.
-
Remove left and right air guide hose to charge air cooler by loosening spring clips and hose clamps.
-
Loosen clamp - 2 -
-
Disconnect electrical connector - 4 -.
-
Remove nut - 3 - and bolt - 1 -.
-
Remove intake downward.
-
Remove bolts - arrows - by releasing air ducts at left and right and tipping in direction of headlamps.
-
Tip top edge of charge air cooler back slightly.
-
Disengage charge air cooler from lower mounting points by raising it.
-
Slide charge air cooler in direction of engine.
-
Support charge air cooler from below so that it cannot sink.