TT Roadster L4-2.0L Turbo (BPY) (2008)
/Page-1906004.png)
-
Remove bolts - arrows - by releasing air ducts at left and right and tipping in direction of headlamps.
-
Tip top edge of cooler back slightly.
-
Disengage cooler from lower mounting points by raising it.
-
Slide cooler in direction of engine.
-
Support cooler from below so that it cannot sink.
NOTE: Do not bend or stretch lines or hoses as compressor and refrigerant lines/hoses may be damaged.
-
Remove bolts - arrows -.
-
Remove condenser from cooler.
-
Remove condenser downward.
Installing
-
Torque specification: Bolts for securing compressor (to charge air cooler) - 5 Nm
Installation is done is reverse order, observe the following:
NOTE: The removed condenser contains refrigerant oil that must be returned to the refrigerant circuit (with the new condenser).
-
Ensure sealing strips - arrows - have adhered correctly to condenser - A -.
