TT Roadster L4-2.0L Turbo (BPY) (2008)
Housing Assembly HVAC: Description and Operation
Air Intake Housing
Air Intake Housing
1
Fresh air intake
‹› The air is extracted out of the plenum chamber. Refer to=> [ Fresh Air Intake Cover ] See: Body and Frame/Cowl/Cowl Moulding /
Trim/Service and Repair/Fresh Air Intake Cover.
2
Removing air from the passenger compartment (in recirculating air mode)
‹› The air is taken from the passenger footwell under the glove compartment.
3
Outlet to right front footwell vent
4
Outlet to right instrument panel vent
5
Outlet to center instrument panel vents
6
Outlet to left instrument panel vent
7
Outlet to left front footwell vent
8
Outlet to instrument panel defroster vents instrument panel
‹› From May 2007, a A/C air distribution housing with a defroster door in the air outlet to the defroster vents in the instrument panel without a
side cut-out is gradually being installed. With the introduction of the flap with the side cut-out, the Climatronic Control Module ( J255) is
changed. Refer to => [ A/C Air Distribution Housing Defroster Outlet Flap ] See: Air Door/Description and Operation/A/C Air Distribution