TT Roadster L4-2.0L Turbo (BPY) (2008)
Headlamp Bulb: Service and Repair
High Beam Bulb, Replacing
High Beam Bulb, Replacing
Removing
CAUTION:
-
Switch off all electrical consumers.
-
Switch off ignition and remove ignition key.
-
Turn light switch into "0" position.
Right headlamp:
-
Remove EVAP canister up from bracket - arrow - and lay aside with lines connected.
Continuation for both sides:
-
Remove high beam housing cover - 2 - from headlamp housing - arrow A -.
-
Remove bulb - 3 - from spring clips - B arrows -.
-
Disconnect harness connector - 1 - at high beam bulb.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
-
Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that
evaporates on the bulb during operation can cause the glass to cloud over.
-
When installing cap, ensure proper seating. Water intrusion will damage headlamp.
-
Insert bulb in housing.
-
Place bulb on lower spring clip.
-
Press bulb in housing over upper spring clamp resistance.