TT Roadster L4-2.0L Turbo (BPY) (2008)
Alignment: Service and Repair
Measurement Procedure
Measurement Procedure
Special tools, testers and auxiliary items required
‹› Alignment Computer (V.A.G 1813) or VW-/Audi-approved alignment unit
‹› Brake Pedal Actuator (V.A.G 1869/2)
‹› Insert Tool 18 mm (T10179)
‹› Shock Absorber Set (T10001)
Work Procedure, Vehicle Alignment, Overview
‹› Vehicle must only be measured at empty weight => See: Testing and Inspection/Component Tests and General Diagnostics.
Observe the following work sequence!
1
Check front axle camber and adjust if necessary.
a
Front and all wheel drive, refer to => [ Front Axle Camber, Adjusting ] See: Front Axle Camber, Adjusting
2
Check rear axle camber and adjust if necessary.
a
Front and all wheel drive, refer to => [ Rear Axle Camber, Adjusting ] See: Rear Axle Camber, Adjusting
3
Check rear axle toe and adjust if necessary.
a
Front and all wheel drive, refer to => [ Rear Axle Toe, Adjusting ] See: Rear Axle Toe, Adjusting
4
Check front axle toe and adjust if necessary.
a
Front and all wheel drive, refer to => [ Front Axle Toe, Adjusting ] See: Front Axle Toe, Adjusting.
5
If adjustments were made to the suspension during alignment on vehicles with ESP or ABS, calibrate the steering angle sensor (G85) and
reprogram the steering, refer to => [ Wheel Alignment ] See: Wheel Alignment.
6
On vehicles with level control sensor, headlamp range control basic setting must be performed after a vehicle alignment, refer to => [ Rear Level
Control System Sensors ].
Use Vehicle Diagnosis, Testing and Information System (VAS 5051B) for this. => Vehicle Diagnosis, Testing and Information System VAS 5051 in
"Guided Fault Finding" function.
-
Insert brake pedal depressor (V.A.G 1869/2 ).