TT Roadster L4-2.0L Turbo (BPY) (2008)
-
Slide the small yellow crimp connector onto both stripped, uninsulated wire ends on the vehicle-specific single wire and crimp them using crimp
pliers.
NOTE: Do not crimp wire insulation.
After crimping, crimp connections must be heat-shrunk using hot air gun to prevent moisture penetration.
-
Put Shrink Tip For Hot Air Gun VAS 1978/15 on to Hot Air Gun, 220 V/ 50 Hz VAS 1978/14.
CAUTION:
Risk of damaging surrounding components.
-
When heat-shrinking crimp connections, be careful not to damage any other wiring, plastic parts or insulating material with the hot
nozzle of the hot air gun.
-
Always observe operating instructions of heat gun.
-
Heat crimp connection using hot air gun lengthwise from center outward until it is sealed completely and adhesive comes out the ends.
-
This is how the completed repair location with individual crimp connector should appear.