TT Roadster L4-2.0L Turbo (BPY) (2008)
The following exchangeable heads are available for the Crimping Pliers (Base Tool) VAS 1978/1-2 :
-
Exchangeable Head, 0.35-2.5mm VAS 1978/1-1
-
Exchangeable head, 4.0-6.0 sq.mm VAS 1978/2 A
-
Slide the crimp connector onto the vehicle-specific single wire at one side and onto repair wire at the other side.
-
Crimp the crimp connection at both wire ends using crimp pliers.
-
Repeat this procedure on the other wire ends.
NOTE: Do not crimp wire insulation.
After crimping, crimp connections must be heat-shrunk using hot air gun to prevent moisture penetration.
-
Put Shrink Tip For Hot Air Gun VAS 1978/15 on to Hot Air Gun, 220 V/ 50 Hz VAS 1978/14.
CAUTION:
Risk of damaging surrounding components.
-
When heat-shrinking crimp connections, be careful not to damage any other wiring, plastic parts or insulating material with the hot
nozzle of the hot air gun.
-
Always observe operating instructions of heat gun.
-
Heat crimp connection using hot air gun lengthwise from center outward until it is sealed completely and adhesive comes out the ends.
-
This is how the completed repair location with the inserted wire and two crimp connectors should look.