TT Roadster L4-2.0L Turbo (BPY) (2008)
Wiring Harness: Removal and Replacement
Primary Connector With Special Connector Systems
Primary Connector with Special Connector Systems
Procedure
‹› If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts => [
Secondary Lock ].
Fasten contacts:
-
Guide release tool (that fits terminal housing) into release channel on terminal housing - arrow -.
-
Grasp contact at wire and push gently into terminal housing.
‹› By pushing contact in direction of terminal housing, contact retaining tabs are lifted off the housing shoulder and can be released using release
tool.
-
At the same time, push release tool in direction of terminal housing and pull released contact out of terminal housing - arrow -.
-
Remove release tool after removing contact from housing.
GT 150/280 contacts: