TT Roadster L4-2.0L Turbo (BPY) (2008)
-
Slowly depress the accelerator pedal to Wide Open Throttle (WOT) stop while observing the percentage display. The percentage display must
increase uniformly.
-
Using the scan tool, check the throttle valve position (absolute) at Wide Open Throttle (WOT) stop:
-
End diagnosis and switch ignition off.
If the specified values are not obtained:
-
Remove the Throttle Valve Control Module (J338 ) far enough so that the electrical connector terminals are reached.
-
Disconnect the Throttle Valve Control Module ( J338) electrical harness connector - arrow -.
Checking resistance
-
Using a multimeter, check the Throttle Drive (for Electronic Power Control (EPC)) (G186) at Throttle Valve Control Module (J338) terminals 3 to
5 for resistance.