TT Roadster L4-2.0L Turbo (BPY) (2008)
NOTE:
-
To check resistance values "tank full" or "tank empty", the fuel delivery unit must be removed and the floater of the sensor must be placed in
upper or lower end position.
-
If measured value is 0 ohm there is a short circuit. If measured value is infinity ohms there is and open circuit in the wiring.
-
With fuel level sensor G removed, the following values are obtained because of the greater deflection of the floater arm:
Fuel Level Sensor G removed:
-
Sensor at lower stop: approximately 290 ohms.
-
Sensor at upper stop: approximately 50 ohms.
-
Connect multimeter between terminal - 3 - and - 4 - for resistance measurement.
Fuel Level Sensor G installed or removed:
-
Any sensor position: Approximately 340 ohms.
Assembly is in reverse order of removal, note the following:
TT Coupe:
-
Install rear seat bench.
TT Roadster:
-
Install right rear panel side trim.