TT Roadster L4-2.0L Turbo (BPY) (2008)
Specified value: about 5.0 V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to 2.0 Liter 4-Cyl. 4V Turbo Fuel Injection & Ignition, Engine Code(s): BWA. Repair Group 24.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ replacing ] See: Engine Control Module/Testing and Inspection/Engine Control
Module (ECM) (J623).
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor (G40) electrical harness connector to the Engine Control Module (ECM)
electrical harness connector T60 for resistance.
Specified value: 1.5 ohms Max.