TT Roadster L4-2.0L Turbo (BPY) (2008)
1
Radial compensation, replace if damaged
2
Combustion chamber sealing ring (Teflon sealing ring), replace, the ring must not be greased or handled with any other lubricants when installing.
3
Groove on fuel injector
4
Spacer ring, replace if damaged
5
O-ring (replace, coat lightly with clean engine oil when installing)
6
Support ring (via this support ring, fuel rail utilizes the force to hold the fuel injector in place in the cylinder head).
‹› With fuel injector installed, the radial adjustment - 1 - is clipped into the support ring - 6 -. To remove the fuel injector, the support ring must be
separated from the fuel injector in order to install puller (T10133/2) into the indentation on the fuel injector - 3 -.
-
Cover open intake channels with a clean rag.
-
Disconnect electrical harness connector at fuel injector that is to be removed.
-
Bend retaining tabs of radial compensation to the side using a screwdriver and pull off support ring from fuel injector.