TT Roadster L4-2.0L Turbo (BPY) (2008)
Specified value: 12.0 to 20.0 ohms (at approx. 20° C)
If the specified value was not obtained:
-
Replace the malfunctioning Fuel Injector. Refer to 2.0 Liter 4-Cyl. 4V Turbo Fuel Injection & Ignition, Engine Code(s): BWA. Repair Group 24.
If the specified value was obtained:
Checking activation
-
Connect a diode test lamp (12V) to the electrical harness connector terminals 1 and 2 of the Fuel Injector to be tested.
-
Operate the starter and test the activation of the Fuel Injector.
LED should flicker.
-
Switch the ignition off.
If LED does not flicker:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to 2.0 Liter 4-Cyl. 4V Turbo Fuel Injection & Ignition, Engine Code(s): BWA. Repair Group 24.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ replacing ] See: Computers and Control Systems/Engine Control