TT Roadster L4-2.0L Turbo (BPY) (2008)
-
Start the engine and let it run at idle.
-
Using a multimeter, check the Mass Air Flow (MAF) Sensor (G70) electrical harness connector terminal 3 to Ground (GND).
Specified value: battery voltage.
-
Switch the ignition off.
If specified value was not obtained:
-
Check the Mass Air Flow (MAF) Sensor (G70) electrical harness connector terminal 3 to the Power Supply Relay (terminal 50) (J682) terminal
2/30 for an open circuit, a short circuit to each other, Battery (+), and Ground (GND).
Specified value: 1.5 ohms max.
If no malfunction is detected in the wiring and the voltage supply was OK:
Checking electrical circuit
If the manufacturers test box is being used. Perform the following step.