TT Roadster L4-2.0L Turbo (BPY) (2008)
Communications Control Module: Service and Repair
Data Bus On Board Diagnostic Interface J533, Removing And Installing
Removing
-
If the control module is replaced, select "Replace" function for the respective control module in "Guided Functions".
CAUTION:
-
Switch off all electrical consumers.
-
Switch off ignition and remove ignition key.
-
Remove drivers storage compartment.
-
Remove screw - arrows - and remove air duct - 1 -.
-
Release retaining clips - 1 and 6 - by pressing them together - arrows -.
-
Disengage retaining tab - 2 - on bracket - 3 -.
-
Disconnect electrical connector - 4 - and remove Data Bus On Board Diagnostic Interface J533 - item 5 -.
Installing
Install in reverse order of removal, noting the following:
-
Install air duct.
-
Install drivers storage compartment.