TT Roadster L4-2.0L Turbo (BPY) (2008)
-
Then remove knee airbag nuts - 2 - on lower support - 3 -.
-
Remove knee airbag from glove compartment. Guide airbag connector - 1 - through glove compartment opening - 4 -.
-
Place airbag unit so padding faces upward.
Installation
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
CAUTION!
‹› Observe safety precautions for work on airbags. Refer to => [ Airbag System General Safety Precautions ] See: Service Precautions.
‹› Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "discharge static electricity". This
can be done by touching door striker, for example.
-
After installing knee airbag - 2 -, insert rubber mat - 1 - in glove compartment - 3 - in - direction of arrow -. Rubber mat must be clipped into
groove - arrow -.