TT Roadster L4-2.0L Turbo (BPY) (2008)
Installation
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
-
Position circuit board - 4 - from Front Passenger's Seat Occupied Sensor (G128) - 2 - in cut-out - 3 - in seat padding - 1 -.
-
Align Front Passenger's Seat Occupied Sensor ( G128) - 2 - on seat padding - 1 - as shown in illustration.
CAUTION!
The new Front Passenger's Seat Occupied Sensor ( G128) should be installed in the same location on the seat upholstery as the old seat
occupied sensor.
-
Remove protective foil and adhere Front Passenger's Seat Occupied Sensor (G128) - 2 - to seat padding - 1 -.
‹› Ensure Front Passenger's Seat Occupied Sensor (G128 ) is not covered by seat heater element heating coils.