TT Roadster L4-2.0L Turbo (BPY) (2008)
Braking Sensor/Switch: Service and Repair
Brake light switch, removing and installing
Removing
Note:
^
The brake light switch is installed on brake master cylinder.
^
The brake light switch is not adjusted.
-
Disconnect electrical connector - 1 -.
-
Remove brake light switch retaining bolt - 2 - from brake master cylinder.
-
Remove brake light switch down from brake master cylinder and remove switch upward from retaining tab.
Installing
-
Installation is in reverse order of removal. Ensure top of switch is seated correctly in retaining tab when doing so.
Note:
^
The brake light switch is not adjusted.