TT Roadster L4-2.0L Turbo (BPY) (2008)
Wiring Harness: Procedures
Contacts In Terminal Housing, Repairing
Contacts In Terminal Housing, Repairing
Procedure
-
First, open or release secondary lock of the contact housing (where applicable).
-
Release contact (primary lock) using appropriate release tool - A -.
-
Pull contact back out of housing - arrow - at single wire (with single wire seal if necessary).
-
Cut off old contact (with the single wire seal) from vehicle-specific wiring harness.
-
Determine yellow repair wire with correct contact from Wiring Harness Repair Set VAS 1978A.
-
Free up wire to be repaired approximately 20 cm on both sides of the repair point.
CAUTION:
Risk of damaging the electrical wires.
-
Free up wrapped wiring harnesses carefully.
-
If necessary, remove wiring harness wrapping using knife.
-
Slide new repair wire contact into corresponding contact housing compartment until it engages.
-
If necessary, install single wire seal on repair wire.