TT Roadster L4-2.0L Turbo (BPY) (2008)
Alignment: Service and Repair
Front Axle Toe, Adjusting
Front Axle Toe, Adjusting
-
To loosen or tighten lock nut - B -, counterhold at tie rod end - A - with a wrench.
-
Loosen lock nut - B -.
-
Adjust toe on left and right-hand wheels with hex - C -.
‹› Make sure that boot on steering gear is not damaged or twisted. Twisted boots wear out quickly.
‹› Only tighten lock nuts when vehicle is resting on ground - tie rod end must be parallel to suspension strut steering lever.
-
Tighten lock nut - B - and check toe-in value again.
After tightening lock nut - B - it is possible that the value deviates slightly.
If the measured toe nevertheless lies within the tolerance, the adjustment is correct.
Tightening specifications, refer to => [ Electro-Mechanical Power Steering, Servicing Assembly Overview ] See: Steering/Service and
Repair/Removal and Replacement