TT Roadster L4-2.0L Turbo (BPY) (2008)
-
Slide boot - 2 - onto tie rod - 1 -, pay attention to correct position when doing this.
-
Slide boot onto steering gear housing until it stops.
-
Tighten new clamp using (VAS 6199) to the extent depicted in the illustration.
Further installation is in the reverse sequence to removal.
Tightening specifications, refer to => [ Electro-Mechanical Power Steering, Servicing Assembly Overview ] See: Service and Repair/Removal and
Replacement
After the installation the vehicle must be measured.
-
Perform vehicle alignment, refer to => [ Measurement Procedure ] See: Alignment/Service and Repair/Measurement Procedure.
-
Perform basic setting for Steering Angle Sensor ( G85) via => Vehicle Diagnosis, Testing and Information System (VAS 5051B), "Guided Fault
Finding".
-
Perform a basic setting and program the steering on vehicles with Generation II steering gear => vehicle diagnosis, testing and information system
(VAS 5051B), "Guided Fault Finding".