TT Roadster L4-2.0L Turbo (BPY) (2008)
Control Arm Bushing: Service and Repair
Transverse Link Bonded Rubber Bushing
Special tools, testers and auxiliary items required
‹› Assembly Tool (T10219)
‹› Thrust Plate (VW 402)
‹› Punch (VW 411)
Bonded rubber bushing, pressing out
-
Press out bonded rubber bushings as depicted in the illustration.
1 - Punch (VW 411)
2 - Tube (T10219/1)
3 - Thrust plate (VW 402)
Bonded rubber bushing, pressing in
Bonded rubber bushing must be installed at an angle to prevent damaging it when pressing in. Bonded rubber bushing settles straight while pressing
in.
-
Apply installation lubricant. Refer to thinned with water in a ratio of 1:20 to the outside of the bonded rubber bushing.
-
Place bonded rubber bushing on at an angle (in direction of transverse link), when doing this the lip - arrow - must slip into hole as shown in the
illustration.