TT Roadster L4-2.0L Turbo (BPY) (2008)
-
Hold wheel bearing housing tightly and remove bolts -arrows-.
-
Pull connecting link -1- out from trailing arm.
-
Remove wheel bearing housing.
Installing
Installation is in reverse of removal, with special attention to the following:
-
Install bolt for tie rod -1-, upper transverse link -2- and lower transverse link -3- and tighten by hand.
-
Hand-tighten connecting link -arrow- on trailing arm.
Only tighten bolts for longitudinal control arm/wheel bearing housing if all other components (especially spring and shock absorber) of appropriate
suspension are already installed. To tighten, suspension must be unladen. Only then will longitudinal control arm and wheel bearing housing move to
required position -arrows-.
The sequence of the following work steps must absolutely be observed!