TT Roadster L4-2.0L Turbo (BPY) (2008)
‹› Tightening sequence => [ Transmission side subframe mount tightening
sequence ]
17
Bolt
‹› 40 Nm plus an additional 90°
‹› Transmission plate to transmission
‹› Replace
18
Bolt
‹› 40 Nm plus an additional 90°
‹› Transmission plate to transmission
‹› Replace
19
Transmission plate
‹› Tightening sequence => [ Transmission side subframe mount tightening
sequence ]
Transmission side subframe mount tightening sequence
-
Insert transmission plate - A - between transmission and transmission mount support arm.
-
Tighten transmission plate on transmission.
-
Raise transmission to transmission mount support arm with Engine Support Bridge (10 - 222 A) spindle.
-
Next, install bolts - 2 -, but only hand tight.
CAUTION!
Risk of damaging threads in transmission mount support arm due to bolts inserted crooked.
‹› Before installing bolts - 2 -, transmission plate and transmission mount support arm must be absolutely parallel to each other. If necessary,
raise rear of transmission with trolley jack.
-
Only tighten bolts if subframe is installed => Suspension,
Wheels, Steering 40 Description and Operation and subframe mounts are adjusted =>
Engine Mechanical 10 Diagnosis and Testing.