TT Roadster L4-2.0L Turbo (BPY) (2008)
‹› If the rubber bonded bushing should be replaced separately, it can be removed with the Counter-Support, for example (Kukko 22/1) and the
Internal Puller 12 to 16 mm, for example (Kukko 21/1). Refer to => [ Rubber Bonded Bushing,
Removing ]
"Upper Rear" - A - and " Lower Rear" - B - Rubber Bonded Bushings, Pulling In
-
Lay a washer with internal diameter 15 mm and outer diameter no smaller than 27 mm on Spindle (3346/2) before it is installed.
"Lower Front" Rubber Bonded Bushing, Removing
-
To prevent oil from leaking out of the final drive in the following step, seal off both vent pipes.