TT Roadster L4-2.0L Turbo (BPY) (2008)
/Page-1148002.png)
6. Clamp
^
Replace
^
Tensioning or
7. Dished washer
^
Installed position
8. Spacer ring (plastic)
^
Installed position
9. Securing ring
^
Replace
^
Insert in shaft groove
10. Protective boot for inner constant velocity joint
^
Without ventilation bore
^
Check for tears and scuffing
^
Drive off constant velocity joint using drift
^
Coat sealing surface with D 454 300 A2 before installing on constant velocity joint
11. Clamp
^
Replace
^
Tensioning or
12. Backing plate
13. Bolt
^
Pre-tightening torque: 10 Nm
^
Tightening torque M8: 40 Nm
^
Tightening torque M10: 70 Nm
14. Securing ring
^
Replace
^
Removing and installing using VW 161 A
15. Gasket
^
Bonding surface on constant velocity joint must be free of grease and oil!
16. Inner constant velocity joint
17. Dished washer
^
Installed position
Special tools, testers and auxiliary items required
