TT Roadster L4-2.0L Turbo (BPY) (2008)
Wheel Bearing: Removal and Replacement
Wheel Bearing Housing
Wheel Bearing Housing
Special tools, testers and auxiliary items required
‹› Ball Joint Puller (3287A)
‹› Torque Wrench (V.A.G 1332)
‹› Engine/Transmission Jack (V.A.G 1383 A)
‹› Angle Wrench (V.A.G 1756)
‹› Spreader (3424)
Removing
-
Loosen the drive axle threaded connection on the wheel side.
Refer to => [ Hex Bolt between Drive Axle and Wheel Hub, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and Repair/Front
Suspension/Hex Bolt between Drive Axle and Wheel Hub, Loosening and Tightening.
Refer to => [ 12-Point Bolt between Drive Axle and Wheel Hub, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and Repair/Front
Suspension/12-Point Bolt between Drive Axle and Wheel Hub, Loosening and Tightening.
-
Remove wheel.
-
Remove the brake caliper and secure it to the body using wire.
-
Remove brake line and electrical line bracket from wheel bearing housing.
-
Remove the ABS speed sensor. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems
-
Remove disc brake.
-
Remove cover plate from wheel bearing housing.
-
Loosen tie rod end nut, but do not remove yet.
-
Press off tie rod ball joint from wheel bearing housing using (3287A) and now remove nut.
-
On vehicles with a level control system sensor, remove the nut from the linkage on the transverse link.