TT Roadster L4-2.0L Turbo (BPY) (2008)
-
Insert (3424) into slot of wheel bearing housing.
-
Using a ratchet and the (3424), open the wheel bearing housing slot.
-
Pull wheel bearing housing with ball joint down from shock absorber tube and remove.
Installing
Installation is in reverse order of removal, with special attention to the following:
Tightening specifications, refer to => [ Wheel Bearing Housing and Wheel Bearing Unit, Assembly Overview ] See: Steering and
Suspension/Suspension/Rear Knuckle/Service and Repair/Front Suspension/Wheel Bearing Housing and Wheel Bearing Unit, Assembly Overview
Tightening specifications, refer to => [ Subframe, Stabilizer Bar, Transverse Link, Ball Joint, Level Control System Sensor Assembly Overview ] See:
Body and Frame/Frame/Subframe/Front Subframe/Service and Repair/Subframe, Stabilizer Bar, Transverse Link, Ball Joint, Level Control System
Sensor Assembly Overview
-
Replace locking element after each removal item - 11 - => [ Locking Element ] See: Body and Frame/Frame/Subframe/Front Subframe/Service
and Repair/Subframe, Stabilizer Bar, Transverse Link, Ball Joint, Level Control System Sensor Assembly Overview.
-
Align nuts - arrows - according to markings made earlier and tighten.