TT Roadster L4-2.0L Turbo (BWA) (2009)
/Page-1918002.png)
Installation
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
CAUTION!
‹› Observe safety precautions for work on airbags. Refer to => [ Airbag Safety Precautions ] See: Restraint Systems/Air Bag
Systems/Air Bag/Service Precautions.
‹› Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "discharge static electricity". This
can be done by touching door striker, for example.
-
Install Driver Seat Height Adjustment Motor (V245) or (V246) - 3 - in new seat pan lower frame - 4 -.
-
Install Driver Seat Inclination Adjustment Motor (V243) or (V244) - 1 - in new seat pan lower frame - 4 -.
‹› Ensure that electrical connections are pushed in as far as stop and engage with a click.
-
Switch on ignition.
CAUTION!
Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired correctly, they may
deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
-
Connect battery ground cable with ignition switched on.
-
If Airbag Malfunction Indicator Lamp (MIL) (K75 ) indicates a fault after installation, DTC memory must be checked, deleted and checked again.
Refer to => Vehicle Diagnosis, Testing and Information System (VAS 5051B).
