TT Roadster L4-2.0L Turbo (BWA) (2009)
/Page-345005.png)
‹› Turning over the engine is performed at the center bolt of the crankshaft.
-
Set engine to TDC at cyl. 1, by turning crankshaft in engine running direction at center bolt of crankshaft toothed belt sprocket. Marking on
camshaft sprocket and marking on crankshaft must be positioned at TDC for cyl. 1 - arrows -.
-
Set marking on chain sprocket of differential shaft - arrow - opposite alignment bore. Secure chain sprocket in this position using connecting pin
(T10027). Place chain on to differential shaft chain sprocket.
