TT Roadster L4-2.0L Turbo (BWA) (2009)
/Page-594003.png)
Specified value: 1.0 to 5.0 ohms (at 20° C)
If the specification was not obtained:
-
Replace the Throttle Valve Control Module ( J338 ).
If the specification was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to 2.0 Liter 4-Cyl. 4V Turbo Fuel Injection & Ignition, Engine Code(s): BWA. Repair Group 24.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ replacing ] See: Engine Control Module/Testing and Inspection/Engine Control
Module (ECM) (J623).
-
Using a Multimeter, check the Throttle Drive (for Electronic Power Control (EPC)) (G186) at Throttle Valve Control Module (J338) electrical
harness connector terminals to the Engine Control Module (ECM) ( J623) electrical harness connector T60 terminals for resistance.
