TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
Trim Panel: Service and Repair
Luggage Compartment Side Trim
Luggage Compartment Side Trim
Special tools, testers and auxiliary items required
‹› Trim Removal Wedge (3409)
Removing
-
Fold luggage compartment floor mat completely forward.
-
Remove the luggage compartment floor covering.
-
Remove rear cross panel trim. See: Rear Cross Panel Trim
Only right luggage compartment side trim
-
Using a screwdriver, pry out light - 1 - on side - 3 -.
The - arrow - points to the direction of travel.
-
Disconnect the connector - 2 -.
Procedure for both sides
-
Unclip luggage compartment side trim with Trim Removal Wedge (3409).
Installation
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
‹› If trim clamps remain in body mounting points, remove these and insert them in trim.
‹› Check clamps for damage or deformation, replace if necessary.
-
Stretch rear lid seal lip over luggage compartment side trim.