TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
/Page-514008.png)
-
Insert new seals - A - into connections of heater core - D -.
-
Push both coolant pipes - C - into heater core connections - D -.
-
Check seating of seals - A - again between coolant pipes - C - and connections of heater core - D -.
-
Secure both coolant pipes - C - and - D - with clamps - B - on heater core.
-
Tighten bolts on clamps - A - to 2.5 Nm.
-
Check seating of both clamps - B - after tightening bolts - A -, clamps must enclose the flange on heater core and coolant pipe completely and must
not touch other components.
-
Thread bolt - A - into connector flange - B - (while doing this make sure bolt is actually threaded into the mounting point intended for it).
