TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
-
Remove inner part of the seal remover (3203) nine turns (approximately 20 mm) from outer portion and secure with knurled-head screw.
-
Lubricate seal remover threaded head, position it, and screw it into the shaft seal as far as possible using strong force.
-
Loosen knurled screw and turn the inner portion against the crankshaft until the seal is pulled out.
-
Remove toothed belt crankshaft sprocket bolt.
-
Secure seal remover in a vise at the flat spots and remove the seal using pliers.
-
Clean shaft seal running and sealing surfaces.
-
Remove oil residue on crankshaft pins using a clean rag.
-
Position guide sleeve (T10053/1) on crankshaft pin.